openVFF5

VFF5

  • A hand-held, batterypowered tool, the VFF5 projects a highly visible red light into a fibre optic cable. The VFF5 is used to check continuity of cabling between termination points and to locate bends or breaks in fibres at splicing and termination points
  • Useful over a distance of approximately 5km (3.1mi) into multimode fibre and single-mode fibre. Use it as a stand-alone first-line basic troubleshooting tool, or in conjunction with an OTDR to pinpoint faults. Any breaks will be seen as a conspicuously glowing or blinking red light area (in 3mm or smaller cables)
  • Equipped with a highpower, day light visible 650nm laser diode which operates either in continuous or flashing mode. The design prevents battery drain due to accidental activation of the tool while inside a tool pouch
  • Packaged in a pocket-sized, rugged metal housing and is fitted with 2.5 mm universal connector that accepts ST, SC and FC optical connectors
Add to wishlist
Share
Category

    Used to verify continuity, test and find breaks in fibre links, locate pinched fibre strands in termination cabinets, or anywhere fibre optic cables are terminated and subject to mechanical damage.

    The VFF5 is also an excellent aide to technicians terminating mechanical splices or pre-polished connectors where leaking light is an indicator of a poor fibre cleave or other misalignment.

    Accessories

    Part No.Recommended Accessories
    33-963-11Fibre tip pen cleaner to clean 1.25mm connectors and feedthroughs (LC)
    33-963-10Fibre tip pen cleaner to clean 2.5mm connectors and feedthroughs (SC, ST, FC)
    135051Male FC (2.5mm) to Female LC (1.25mm) connector allows LC connections to interface with FC devices. Contents: One adapter. Order two pieces when using with FiberMASTER or other optical loss test sets.
    Part No. VFF5

    VFF5 – VISUAL FAULT LOCATOR Fibre optic cable continuity tester, fault detector (VFL)

Related Products

LanTEK III

LanTEK III
PoE Pro

PoE Pro
OTDR II

OTDR II
NaviTEK NT

NaviTEK NT